The “printer setup incomplete” error for HP printers commonly indicates that the printer setup process wasn’t fully completed or some configuration step failed. To resolve this, try these key steps:
1. **Reset the printer** by turning it off, disconnecting power for 1-2 minutes, then turning it back on to clear minor glitches[4].
2. **Restore defaults on the printer**: For some models (e.g., HP LaserJet M110we), printing the status page, accessing the printer’s IP via a browser, and performing “Restore defaults” under System/Service can fix configuration issues[2].
3. **Check and ensure your printer and computer are on the same Wi-Fi network**. Printing a network config page from the printer can verify this. Reconnect Wi-Fi if necessary[5].
4. **Use the HP Smart app** for setup or to detect the printer, and follow all prompts to complete registration and setup[1][5].
5. **Update the printer firmware** through HP Smart if possible[1].
6. **Check and disable temporarily your antivirus/firewall**, as these can block printer communication during setup. Re-enable after setup with exceptions for the printer[3].
7. **Manually install the latest printer drivers** from HP’s website for your printer model to ensure compatibility, especially on Windows 11 systems[3][5].
8. **Verify Windows services like Print Spooler are running** via Services (services.msc)[5].
If these steps don’t resolve the issue, try a hard reset by holding the printer’s power button for 10 seconds until it restarts[1].
Following this procedure should address the common causes behind the HP “setup incomplete” error and complete the printer setup successfully.